CET9000GQ0 Whirlpool Washer Dryer Combo - Parts

This dispenser hose is for washers and carries the contents of the dispenser drawer to the washer tub.

This is the replacement bellow clamp for your washer. It is approximately 18 inches in diameter and is sold individually. The bellow clamp goes around the bellow in your washer and holds it in place o...

The door boot spring clamp or outer bellow clamp on your washer is designed to keep the door boot in place. It is circular in shape, and you will find it wrapped around the bellow. To remove the old c...

This hi-limit thermostat acts as as safety mechanism that keeps the dryer from overheating. Once the dryer temperature reaches a certain point, this piece will shut down power to the heating element.

This part is located behind the control panel. It helps determine the level of water in the washer. As the water fills the hose, while tub is filling, it will push the air against a diaphragm inside t...

This shaft is for the front with right hand thread. Sold individually.

This part regulates the temperature of the water in the tub. The sensor is located in the heating element.

Water inlet valve controls the water flow into the washer. Fits some washers in the following series: Kenmore 110; Whirlpool CHW, WFW and YWFW; Maytag CHW, MHN, MHP, MHWE, MHWZ and YMHWE; Amana NFW...

This nut is sold individually. Size: 3/8-16

This part is located on the drum roller support shaft.

This part is an electrical connector where you can attach wires. This part does NOT included the wires, screws, and nuts. Must be order separately