OEM DeWALT Nibbler & Shears Parts & Accessories

Power Cord

$17.56

Fix Number: FIX10169875
Manufacturer Part Number: 330072-98

This power cord is used for power tools and some of the following tools: electric drills, reciprocating saws, jig saws, biscuit joiners, and routers. The power cord is made for double insulated tools and is a two-wire cord with two prongs, but it does not need a ground wire. If there are cuts in the cord insulation, intermittent power during operation, or damaged and bent prongs, then replacing the power cord will solve the problem. The tools needed for this repair are a Phillips screwdriver, small screwdriver, wire cutters/strippers, crimping tool, and terminal (ring or spade). Repair tip: During installation, remember that new cord wires must go correctly into wire terminals. Also, to avoid pinching when the tool case is put back into place, remember to route cord and wires in the right path.

Installation Instructions

John from Hancock, MI

Did not come with grinding disc guard

While unit was unplugged I screwed clamp of guard around grinder. Read more...

Watch the install video

Grinder Motor Brush

$7.87

Fix Number: FIX10106782
Manufacturer Part Number: 445861-25

(Sold Individually) This motor brush is for grinders. The motor brush transfers electric current to the spinning armature in the motor. Unplug the grinder before installing this part. Wear work gloves to protect your hands.

Terminal

$4.99

Fix Number: FIX10173813
Manufacturer Part Number: 464228-00

This is a terminal for your power tools. The terminal attaches to the cord of your machine, and then to the electrical connection on the tool. Through this connection, the electricity travels from the wall, through the terminal, and into your machine. The most common reason for needing to replace this part, is if your machine is plugged in but not turning on.

Insert

$7.33

Fix Number: FIX10177395
Manufacturer Part Number: 5140037-07

Brush Spring

$4.99

★★★★★

1 Review

Fix Number: FIX10173420
Manufacturer Part Number: 445860-00

This is a brush spring and it is used in a variety of power tools. The spring applies force to the motor brush inside the motor. This will keep the brush tight along the armature. If the brush has worn down it will create heat, and the spring will lose tension. If this happens, both parts will have to be replaced.