Dishwasher Elements and Burners

★★★★★

★★★★★

2 Reviews

Fix Number

FIX8260087

Manufacturer Part Number

W10518394

This is a manufacturer-approved heating element and 2 washers. If the dishes in your dishwasher are not drying or the water in the dishwasher is not getting hot, it may be due to a failed heating element. The heating element is not intended to heat the water that enters the appliance but is designed to maintain the heat of the water that enters. This part is located on the bottom of the appliance. Be sure to disconnect the power to the appliance before you begin this repair. Start this repair by disconnecting the wires from the bottom of the element in the back, remove the plastic nuts holding it in place, remove the element, and repeat these steps in reverse order to install the new part. For this beginner repair, you will need a screwdriver, wrench set, and it should be completed in less than 30 minutes.

Fix Number

FIX9494999

Manufacturer Part Number

W10703867

The heater element is located in the bottom of the dishwasher. It is used to maintain the temperature of the water during the wash cycle and to dry the dishes afterwards. If your dishes are not coming out properly cleaned or dried, there may be an issue with your heater element. If you need a new part, this is a genuine OEM replacement. In order to complete this repair, you will need to disconnect the power supply to your dishwasher, remove the water inlet valve, and pull the dishwasher out from underneath the cabinet if applicable.

Fix Number

FIX3653449

Manufacturer Part Number

154825001

This dishwasher heating element is not designed to heat the water that enters it, but is designed to maintain the heat of the water that enters the dishwasher. It is located on the bottom of the dishwasher. NOTE: Brass nuts are NOT included. Must be ordered separately.

Fix Number

FIX12073904

Manufacturer Part Number

WD05X23763

The element heating assembly is found at the bottom of the dishwasher tub, and helps to warm the water in the wash cycle, and dry the dishes afterward. If the water does not heat up during the wash cycle, or the dishes are not being dried properly, you may need to replace the element heating assembly in your dishwasher. This element heating assembly is horseshoe-shaped and is sold individually. To replace your heating assembly, first make sure it has cooled down, then simply slide the connecting tabs out. Replace with a new heating element and your problem should be solved.

★★★★★

★★★★★

1 Review

Fix Number

FIX2355742

Manufacturer Part Number

154665201

This part is not designed to heat the water that enters it, but is designed to maintain the heat of the water that enters the dishwasher and is located on the bottom of the dishwasher. Grommets are included with this part.

Fix Number

FIX11748194

Manufacturer Part Number

WPW10082892

This dishwasher heating element is not designed to heat the water that enters it, but is designed to maintain the heat of the water that enters the dishwasher. It is located on the bottom of the dishwasher.

Fix Number

FIX11748195

Manufacturer Part Number

WPW10082894

This dishwasher heating element is not designed to heat the water that enters it, but is designed to maintain the heat of the water that enters the dishwasher. It is located on the bottom of the dishwasher.

Fix Number

FIX3527787

Manufacturer Part Number

5301DD1001G

Fix Number

FIX7788065

Manufacturer Part Number

AEG72950001

Fix Number

FIX2367647

Manufacturer Part Number

W10283681

This dishwasher heating element is not designed to heat the water that enters it, but is designed to maintain the heat of the water that enters the dishwasher. It is located on the bottom of the dishwasher.