Ask our experts a question about this part and we'll get back to you as soon as possible!
1 question answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched. Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Jessplas
May 5, 2023
How do you change the roller?
For model number NV350
Hi Jessplas, thank you for reaching out. According to our research, to replace the roller follow these steps:
- Lift the latches on both sides of the vacuum to release the dust canister.
- Remove the dust canister from the vacuum by lifting it up.
- Lay down the vacuum to access the bottom panel of the roller compartment.
- Using the metal spludger, pry the two small wheels located at the two bottom corners of the vacuum to remove them.
- Remove the eight 19mm Phillips #2 screws from the plastic cover.
- Remove the two 14 mm Phillips #2 screws from the upper section of the plastic cover.
- Remove the wheels by pulling them out of their axles, away from the vacuum.
- Gently pull the grey lower part of the roller compartment away from the purple upper part of the compartment.
- Lift up and then pull the roller belt off of the roller and the motor to remove it.
- Take out the roller by lifting it out of its tray.
Install the new roller and reassemble all the parts. We hope this helps!
Was this helpful?
Thank you for voting!
✖
Ask a Question
Ask our experts a question on this part and we'll respond as soon as we can.