OEM Hotpoint Ice Maker Parts & Accessories

Ice Maker

$216.23

Fix Number: FIX1993870
Manufacturer Part Number: WR30X10093

The ice maker assembly makes ice by filling the tray with water from the inlet valve, freezing it until solid cubes are formed, and then ejecting them into the ice bucket. This process will repeat until the bucket has reached capacity. If your fridge is no longer making ice, the assembly may need to be replaced. This is a genuine OEM replacement that measures 10 inches by 5 inches in size and will make seven crescent shaped pieces of ice each cycle. The kit is mainly made of white plastic, and includes a 4-pin round plug-in connector, a 6-post plug-in connector, tube, and fill cup. Depending on your frequency of use, the ice maker may need to be replaced every three to ten years. Regular wear and tear is the main reason this part may need to be replaced but be mindful of accidental damage.

Fixes these symptoms

Ice maker dispenses too little ice
Ice maker dispenses too much ice
Ice maker not making ice
See more...

Installation Instructions

marion from raleigh, NC

Ice maker stopped making ice

Super easy. Loosen 2 screws. Disconnect power line. Take out broken part and plug in new part then slide icemaker back in place and tighten 2 screws. Saved me the $89 service call plus whatever they would have overcharged for the part! And no waiting around for repair guy! Read more...

Single Outlet Valve Kit

$67.70

★★★★★

1 Review

Fix Number: FIX304375
Manufacturer Part Number: WR57X10033

This single outlet valve has 1/4 inch compression fittings, and is intended for use with refrigerators that have ice makers that make crescent shaped ice cubes. NOTE: As per the manufacturer this valve has new quick connection. You must cut retaining nut off of the current plastic water line and gently push it into new valve. To remove, depress ring that the tube slides into.

Fixes these symptoms

Ice maker not making ice
Ice maker won’t dispense ice
Leaking
See more...

Installation Instructions

Steven from Hailey, ID

Ice maker was not receiving water - faulty valve solenoid

Unplug refrigerator. Shut off source of water to faulty icemaker valve , disconnect power clip to valve, water in and water out tubing from valve. Install new valve reversing the dismantling steps. Keep in mind that the replacement valve has a slip fitting for the out tubing to the icemaker vs. a threaded connection, and the new mounting bracket may face the new valve in a different orientation than the previous valve - but should be no problem. After re-attaching valve to refer body, restore power, and water supply to icemaker. Monitor new valve for leaks and correct as necessary. This site had my replacement in my hand fast and I saved money doing the repair myself. Read more...