OEM Nutone Bath & Ventilation Fan Parts & Accessories

Heating Element

$75.98

Fix Number: FIX12098594
Manufacturer Part Number: S97020888

This is an OEM heating element for use with ventilation fans and ceiling heaters. Some units allow you to turn the heating function on or off. They are most commonly found in bathrooms to help heat the room. For this repair, you will start by removing the fan cover, disconnect the wire, and remove the nuts. You will then be able to pull the heating element fan housing out, remove the screws, and remove the heating element. The installation of the new part is conducted in the reverse order.

Installation Instructions

Loretta from BRIGHTON, CO

Heater element went out

Took off light cover took out heater blower and heat element. Replaced heat element and put all back together Read more...

Blower Wheel

$39.86

Fix Number: FIX10432533
Manufacturer Part Number: SNT5901A000

This is a blower wheel, which also includes the clip needed to install it. This authentic OEM blower wheel is the components that spins inside the fan housing, to produce airflow. It is made of a durable plastic and is pressed onto the shaft of the mower. The bottom (closed side) of the wheel has an outer diameter of approximately 5-3/4 inches. The top (open side) of the wheel has an approximate outside diameter of 6-3/16-inches. It is about 2-inches tall and is compatible with a 1/4-inch shaft. When viewing it from the open side, it rotates in a clockwise direction.

Lens

$39.86

★★★★★

1 Review

Fix Number: FIX10431960
Manufacturer Part Number: S53740000

Power Unit Assembly

$212.07

Fix Number: FIX10432275
Manufacturer Part Number: S97017705

This is an authentic manufacturer sourced replacement part designed for Nutone exhaust fans. This assembly includes a motor, plastic impeller wheel and a metal housing/bracket. When replacing this assembly you would need a screwdriver. First you would need to remove the plastic cover/grille. Unplug the power unit. Unscrew the old assembly and slide it out. Place power/blower unit into housing so that mounting plate's tabs insert into slots in housing. Secure mounting bracket with screws. Connect the power unit and attach cover/grille.