Ask our experts a question about this part and we'll get back to you as soon as possible!
1 question answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched. Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Dan
April 3, 2023
I need instructions on how to use tool
For model number Fux10382770
Hello Dan, thank you for getting in touch. The instructions for the tool mentioned are as follows:
1. Clip sandpaper into the outboard fastener. Wrap the drum, being careful not to overlap the windings. Hold sandpaper over the inboard slot with your left hand.
2. Hold the tuftool with the red end of the tool pointing away from you. Insert the hook into the outside hole of the fastener lever.
3. Lift the lever with the tuftool, pulling the lever up until it touches the inside of the drum.
4. Turn the tuftool anticlockwise and lower it onto the sandpaper, making sure it is holding the paper tight and opening the
the throat of the fastener.
5. Insert the tapered end of the paper into the slot and the fastener. It may be necessary to trim the tapered end of the paper so that it does not "bottom out" against the inside of the drum. Be sure to leave a gap of at least 1/8" between the tapered strip and the closed end of the slot to allow the strip to be pulled into the fastener as needed. If necessary, trim the outside edge of the paper.
6. Hold the sandpaper in place with your left hand. Rotate the drum slightly towards you with your left hand. Rotate the drum slightly towards you. Pull up on the tuftool and turn the handle clockwise while maintaining upward pressure. Slowly move the tuftool away from you slightly, then down, while easing it out of the hole. This releases the lever in its proper position.
7. All abrasive strips will stretch in use and may stretch enough to allow the take-up lever to reach its lowest position so that it cannot maintain tension on the strip. If this occurs, follow the above procedures to reset the takeup lever. Always remove the tuftool from the machine before operating.
We hope this is helpful!
Was this helpful?
Thank you for voting!
✖
Ask a Question
Ask our experts a question on this part and we'll respond as soon as we can.
This front load washer cleaner removes odor-causing residue. Use it once a month and it will keep your machine fresh and clean. Package comes with 3 tablets.
Fresh Flow Produce Preserver is made for your refrigerator to help keep produce fresh for longer by absorbing the chemical, ethylene, that causes your fruits and vegetables to ripen quicker. Your produce could be fresh f...
Affresh dishwasher Cleaner is specially formulated to help remove limescale and mineral build-up that can be unsightly and could affect your dishwasher's performance. Each tablet is designed to clean inside your machine ...
Make your cooktop shine with Frigidaire ReadyClean Glass and Ceramic Cleaner. Our scratch-free, streak-free formula removes smudges, grease, burnt-on food, dirt and oil, while protecting and polishing to repel dust and d...
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.