OEM Hardwick Wall Oven Parts & Accessories

Flat Style Oven Igniter Kit

$57.79

Fix Number: FIX1573892
Manufacturer Part Number: 12400035

This flat style oven igniter kit is a genuine OEM replacement part for your gas range. When the igniter glows white hot, the heat opens the gas valve and ignites the fuel heating the burner assembly. If your igniter is only glowing orange or red, or not glowing at all, it will need to be replaced. This kit includes the igniter, ceramic wire nuts, an insulation pad, a metal bracket, and a variety of plug ends. This kit can be used for both short or long igniters, and the bake or broil element. However, it is not compatible with ranges that require round style igniters. The igniter has an amperage between 3.3 and 3.6. The element is very fragile and should be handled with care. Before beginning your repair be sure to disconnect both the power and gas supply to your range.

Fixes these symptoms

Element will not heat
Gas igniter glows, but will not light
Gas smell
See more...

Installation Instructions

David from ENCINITAS, CA

Wall oven would take a very long time to ignite.

One of the 2 screws that holds the igniter to the burner assembly was stripped and difficult to get out. Other than that it was an easy fix. Read more...

Range Bake Element

$103.52

★★★★★

2 Reviews

Fix Number: FIX11757472
Manufacturer Part Number: WPY04000066

This bake element with push on wire terminals is located in ranges and ovens. The terminal depth is 3 inches, the total element length is 19 and the wire terminals are 16 inches wide. Detailed installation instructions are found in the manual provided by the manufacturer. If your element is not heating then replacing it can solve your problem.

Fixes these symptoms

Element will not heat
Little to no heat when baking
Oven is too hot
See more...

Installation Instructions

GLENN from CHINO HILLS, CA

Bake element broke in half.

Disconnect electric.
Remove 2 screws.
Pull out old unit.
Disconnect wire connect tabs.
Install new unit.
Connect wire tabs.
Replace 2 screws Read more...

Watch the install video

2 Piece Broiler Pan

$37.51

Fix Number: FIX971245
Manufacturer Part Number: 4396923

The top of this part is now black.

Glass Clip - Black

$14.20

Fix Number: FIX1643208
Manufacturer Part Number: 7112P093-60

This clip helps to hold the exterior glass in place. Order quantity required.

Door Seal - Top

$71.04

Fix Number: FIX11743943
Manufacturer Part Number: WP7212P006-60

This oven door seal is seventeen and a half inches long. It is made of rubber and has a metal hook on either end to hold it in place. This seal sits on top of the glass window pane.

Oven Door Seal

$126.83

Fix Number: FIX11743839
Manufacturer Part Number: WP701650

This oven door seal is twenty-one inches wide. This woven style door gasket is gray in color.

Installation Instructions

Myra from Jackson, TN

Seal was ragged and heat escaping from oven.

From our online order, part was received within 2 days! Removed the door by unscrewing a screw on either side of the bottom of the door, which allowed me to slide the door up and off the spring-loaded hinges. Be careful as the hinges are very tight and are spring-loaded!! Next, I put the door on a heavy mat on the floor. I put the screws from each layer of the door into separate baggies and numbered them so as to remember order to replace. The door will disassemble in several layers. Had to thoroughly clean each layer and be very careful so as to not break the glass. Gasket fit perfectly, and only had to trim about 1/2 inch from each end, and reassembled each layer in reverse of removal. To reattach the door to the hinges, I had a little help from my wife. She used a wooden yardstick to hold the hinges open at an angle to allow me to slide the door down onto the hinges, screws back in and it looked like a brand new oven. Appreciate the service of this company. Don Read more...