OEM Electrolux Microwave Oven Combo Parts & Accessories

SWITCH

$45.04

Fix Number: FIX8769124
Manufacturer Part Number: 5304493153

The relay switch may also be known as the door micro switch and is a part for your microwave. The function of this part is to monitor the door latch and communicate whether the door latch is open or closed to the electronic control board. Before making this repair, you will want to make sure to unplug your microwave and discharge the capacitor. Your microwave capacitor is able to store electricity in large quantities even after it has been unplugged. The most common reason for replacing your relay switch is if the microwave will not turn on but your timer still runs..

Fixes these symptoms

No heat
Won’t turn on
See more...

Installation Instructions

Fred from Farmington, NM

Microwave light would turn on but the turn table would not turn and the heating system did not work.

I first read some blogs about my microwave and foud that several people had the same problem Then I removed the top vent cover(three screws through the vent easy to see and locate. Removed one screw from above the control panel and removed the control panel. This made easy access to the three mico switches that engage the door latch system. the bottom switch should some sign of heat damage (some melting) i ordered the part and reinstalled the peaces I removed and the microwave is working perfectly now. $35.00 dollar fix insted of a $250.00 microwave reolacement. I did not have to remove the microwave from its position in the cabinetry. Read more...

Bake Element

$355.50

Fix Number: FIX3655318
Manufacturer Part Number: 318601604

Fixes these symptoms

Element will not heat
See more...

Installation Instructions

steve from Oswego, NY

oven will not heat up properly. thermal breaker and power ok, broiler unit works. bad oven element.

1) if you are able to access the bottom of oven then, a) remove power from oven by putting the circuit breaker to the 'off' position. b) verify the panel display is blank.c) access bottom of oven. you will see a recessed plate which houses the element. d) remove housing by pulling cotter (hair type)pin and phillips head screw(one total). e) pull both lug wires off element. f) install new element and re-install in reverse order. 2) if you cannot access bottom of oven, then remove power, pull oven from wall and access bottom of oven. follow step c through f above. Read more...