Models
>
R4510
R4510 Ridgid Table Saw
Jump to:
Find Part by Name
Keep searches simple, eg. "belt" or "pump".
Diagrams for R4510
Viewing 9 of 9
Keep searches simple, eg. "belt" or "pump".
$4.99
This is a genuine OEM carbon brush, sold individually. Two are needed in your tool, and we suggest replacing them both at the same time, even if only one requires replacement. This is a very common re...
In Stock
Order within the next 6 hrs and your part ships today!
This is a ball bearing for various power tools. It has an outer diameter of just over 1 inch. The balls distribute weight evenly within your tool by spinning the load, and reducing friction. They redu...
No Longer Available
Special Order
Questions and Answers
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
- < Prev
- 1
- Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.
Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Steve
July 24, 2023
how can i get my blade to adjust to 90°. red line on gauge goes past zero mark
For model number R4510
Hello Steve, thank you for reaching out. Use the following instructions to adjust the blade:
1. Unplug the saw.
2. Unlock the bevel locking lever by pulling the lever all the way to the right.
3. Adjust the bevel angle, turning the handwheel clockwise decreases the angle, bringing the blade closer to 90°.
We hope this information helps!
Was this helpful?
Thank you for voting!