Models > 96141028800

96141028800 Husqvarna Lawn Mower

Jump to:

Find Part by Name

Keep searches simple, eg. "belt" or "pump".
Keep searches simple, eg. "belt" or "pump".
$11.20
This is a single black plastic clipping deflector, also sometimes referred to as a discharge chute, for a lawn mower. This part attaches to the mulcher door on the side of the lawnmower deck. It is re...
In Stock
Order within the next 5 hrs and your part ships today!
This is an OEM part sourced directly from Husqvarna. This handle knob is used on a variety of lawn and garden equipment. Commonly used in lawn mower to secure the handle, and in snow blowers to secure...
In Stock
Order within the next 5 hrs and your part ships today!
This is an OEM part sourced directly from Husqvarna. This grade 8 hex head screw is made of metal and measures approximately 3/8 - 24 x 1 ? 3/8. This screw is commonly used in lawn mowers, snow blower...
In Stock
Order within the next 5 hrs and your part ships today!
In Stock
Order within the next 5 hrs and your part ships today!
In Stock
Order within the next 5 hrs and your part ships today!
This idler pulley is sold independently and includes the pre-installed bearings. It is an exact OEM replacement part for the original. This part is found in walk-behind lawn mowers to supply tension t...
In Stock
Order within the next 5 hrs and your part ships today!
On Order
In Stock
Order within the next 5 hrs and your part ships today!
$6.21
In Stock
Order within the next 5 hrs and your part ships today!
In Stock
Order within the next 5 hrs and your part ships today!
$11.92
In Stock
Order within the next 5 hrs and your part ships today!

Questions and Answers

Be the first to ask our experts a question about this part!

Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer:
Mark from COLUMBUS, OH
Parts Used:
581685101
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Tools:
Socket set
Rear drive wheels bald, no traction
9/16s inch socket, something to prop up one side of the mower (I used a plastic plant pot), and about 5 minutes was all that was needed. Undo the nut on the wheel, remove, replace it with the new one (can't mess it up - just goes on one way which is extremely obvious), replace and tighten the nut -- done. Just that simple. With the new kicks it goes up hill like a champ now (instead of spinning, especially with the grass catcher attached).
2 of 3 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
jerome from ANNISTON, AL
Parts Used:
581952101
Difficulty Level:
Very Easy
Total Repair Time:
15 - 30 mins
Tools:
Pliers, Screw drivers
DRIVE CABLE BROKEN
REPLACED THE DRIVE CABLE.
4 of 11 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!